
KNX shutter/ blind actuator
KNX shutter/ blind actuator-5WG1 523-1CB04
- More information? Contact us about this product
- Add to comparison list
for separate control of one Venetian blind or roller shutter drive per actuator channel with AC motor for 120 V AC and electromechanical limit switches,
with electrically interlocked relays to reverse the direction of rotation, relay contacts rated for 120 V AC, 6 A at p.f. = 1,
with selection whether all actuator channels shall be configured identically or individually,
with automatic adaptation of the objects and parameters to the selected drive type and the desired actuator functions,
with communication objects per actuator channel for moving the sun protection to the limit positions or to stop travel,
with step-by-step adjustment of the blind slats,
with communication objects for moving the solar protection or adjusting the blind slats to an intermediate position (as precisely as drive mechanics permit) via positioning data as percentage values,
with an optional object “Sunshine” for activation / deactivation of sunlight tracking of the slats for shading with greatest possible daylight component,
with save and recall of two solar protection intermediate positions,
with automatic opening of blind slats up to a configured position after the blind has reached the bottom position,
with 8-bit status objects per actuator channel for request or automatic transmission of solar protection position and slat position as percentage values,
with 1-bit status objects per actuator channel for request or automatic transmission of the information that the solar protection is in the upper or lower final position,
with differentiation between automatic and manual mode and with automatic switchover from automatic to manual mode of the respective actuator channel on activation of a bus pushbutton for manual control of the solar protection,
with priority of manual mode over automatic control commands,
with an alarm object either per device or per channel for moving the solar protection to the configured safety position in case of wind alarm,
with blocking of travel to another position, as long as wind alarm is pending,
with travel blocking object per device or per channel for blocking the sun protection in its current position (needed during cleaning of an outdoor Venetian blind e.g.),
with electronics powered by an integrated power supply unit for 120 V AC, 50 Hz,
with a pushbutton for toggling between bus and direct mode,
with yellow LED for display of the activated direct mode,
with two pushbuttons each per actuator channel for drive control in direct mode, integrated in the actuator housing and operational if supplied with 120 V AC and bus voltage, even if bus communication is not operational,
with integrated bus coupling unit with only half a standard bus load,
bus connection via bus terminal and contact system to data rail,
for mounting on DIN rail EN 60715-TH35-7.5,
UL listed.
Brand | Siemens |
Article code | 5WG1 523-1CB04 |
SKU | 5WG1 523-1CB04 |